The daily maintenance of dispensing machine directly affects the service life of dispensing machine. The daily work of dispensing machine maintenance has a great influence on the service life of dispensing machine, including the smoothness of dispensing machine in normal use. The following are the daily maintenance steps of dispensing machine:
1. Replacement of rubber and cleaning of pipeline. At this time, first close the feeding valve, open the discharging valve, after discharging the remaining rubber from the bucket, close the discharging valve, open the feeding valve and pour the cleaning solvent into the storage bucket, activate the body, press the solvent out and flush according to the usual operation mode.
2. If the air pressure intake is abnormal and water gas is found, please remove the water gas in the pressure regulating filter or check whether the air pressure source is abnormal or not. Before glue dispensing machine is used in large quantities, please try a small amount of glue dispensing machine to master the use skills of the product so as to avoid errors. When the test is not a problem, then use double-dropping glue dispensing machine or double-liquid glue dispensing machine to produce large quantities of glue. Vacuum extraction system is used to remove the bubbles produced during mixing, or to put them in a static position for 10-20 minutes before using them, so as to make the gas produced during mixing. The more glue is mixed together, the more glue is removed in time.
3. Clean the machine part regularly to increase its service life. The more the amount of glue mixed together, the faster the reaction will be and the faster the curing speed will be. Therefore, it is necessary to mix the glue reasonably according to the actual production situation, otherwise the waste of glue will be caused. Eliminate accidents and improve production efficiency. Nowadays, liquid control technology and dispensing equipment are widely used in various fields of modern industry.
4. When the machine is out of service for a long time, the power should be unplugged. This will not only prolong the life of the machine, but also save a lot of electricity. With the rapid development of industry, liquid control technology and dispensing equipment are constantly developing to ultra-high precision control, diversification and specialization.
Note: Every time you use it, clean the place you can see, rub it with alcohol. It's better to put oil or butter on the moving parts to keep lubrication. If you don't need to polish the glue for a long time, otherwise it will be solidified in the LED dispenser, and you need money to clean it up. It's very troublesome.